Image Map
< BACK TO THE SEED SHOP  VIEW SEED PLANTING & SPACING GROW GUIDES >

How to Make a Thumb-Controlled Watering Pot

One-click share this page with a friend! Share the

 



To Make: 

Find a suitable “pot.” I love using maple syrup containers but I was successful making other smaller pots with smaller plastic milk bottles. The smaller bottles are easier for children. 

Drill a hole in the center of the cap of your container. I used a 7/32nd drill bit. Next, drill small holes in the bottom. I used a 1/16th drill bit. When using softer plastic containers, it is possible to poke holes instead of using a drill. Make sure the cap is on tight; otherwise the water will not stay inside.




How it works:

It works similar to holding your thumb over the top of a drinking straw.




1. To fill your thumb pot, place into a bucket of water. Do not cover the hole in the top.




2. Hold your finger over the hole in the cap to prevent water from escaping the bottom as you lift.




3. Continue to hold your thumb over the hole as you lift.


4. Take your thumb off the hole when you are ready to water your plants. Removing your thumb allows the water to gently stream out the holes on the bottom.


Enjoy!  Read the full post here:  http://www.funinthemaking.net/2011/05/01/thumb-controlled-watering-pot/



We now accept the following payment methods:

payment methods


or
Image Map
BECOME A BRAND AMBASSADOR. Join our Affiliate Team NOW!   Learn more / JOIN NOW   Get paid weekly 💰💰💰 Highest Commission   LEARN MORE   Earn money when you share our seed store with friends and family.   JOIN NOW   Join our Influencer Program   JOIN NOW   Get paid weekly 💰💰💰 Highest Commission   JOIN NOW   Earn money when you share our seed store with friends and family.   LEARN MORE